Cisco Nexus 9332PQ Hardware Installation Manual page 49

Nx-os-mode switch

Table of Contents

Replacing Components

Step 5

Use a small screwdriver to depress the spring-loaded wire retainer lever on the lower spring-cage wire connector. Insert

your green (ground) wire into the aperture and then release the lever.

Step 6

Use a small screwdriver to depress the spring-loaded wire retainer lever on the middle spring-cage wire connector. Insert

your black (DC negative) wire into the aperture and then release the lever.

Step 7

Use a small screwdriver to depress the spring-loaded wire retainer lever on the upper spring-cage wire connector. Insert

your red (DC positive) wire into the aperture and then release the lever.

Step 8

Insert the connector block back into the power supply. Make sure that your red (DC positive) wire aligns with the power

supply label, "+ DC".

Step 9

Verify that the other ends of the cables are attached to the DC power source and ground. You are then ready to turn on

the DC power source.

Cisco Nexus 9332PQ NX-OS-Mode Switch Hardware Installation Guide

Installing a DC Power Supply

Table of Contents