AEG AS-M 2 Series Installation Manual
Glass-backsheet (standard) module
Hide thumbs
Also See for AS-M 2 Series:
- Installation manual (11 pages) ,
- Installation manual (18 pages) ,
- Installation manual (21 pages)
Related Manuals for AEG AS-M 2 Series
Summary of Contents for AEG AS-M 2 Series
- Page 1 AEG SOLAR MODULES INSTALLATION MANUAL GLASS-BACKSHEET (STANDARD) MODULE SERIES: AS-MXXX2 / AS-MXXX3 / AS-MXXX8 / AS-PXXX8 / AS-MXXX9 / AS-PXXX9 AEG STANDARD MODULE INSTALLATION MANUAL VERSION: GD202008 V1-20...
-
Page 2: Table Of Contents
SOLAR MODULES INSTALLATION 1.2 Product Identification MANUAL 2. Safety 2. 1 General safety Thank you for choosing the reliability of AEG solar 2.2 Handling safety modules. 2.3 Installation safety 2.4 Fire safety This installation manual is intended for dealers and 3. -
Page 3: Product Identification
2.1 General safety EN 50380 Directives it provides information about the main parameters of the module: Product Type, All AEG PV modules should be installed according to Maximum Power, Current at Maximum Power, Voltage all local and national applicable standards, codes and at Maximum power, Open Circuit Voltage, Short Circuit regulations. -
Page 4: Installation Safety
PV output. Do not disconnect modules under load to avoid electrical arcs. AEG STANDARD MODULE INSTALLATION MANUAL GD202008 V1-20... -
Page 5: Fire Safety
AS-Mxxx3 20 A AS-Mxxx8 / AS-Pxxx8 20 A AEG PV modules must be installed and stored in the following conditions: AS-Mxxx9 / AS-Pxxx9 15 A Operating temperature From -40°C to +85°C 2.4 Fire safety Extreme weather cond. -
Page 6: Bolting
Do not dismount, drill or modify the frame or any other part of the PV module, as this will void the AEG PV modules can be installed with: warranty. Please contact our Technical Service should •... -
Page 7: Insertion Systems
Load: positive 2400Pa information, and for a compatibility assessment of the negative 2400 Pa insertion system you wish to use, contact the AEG service team (see Section 6 „Contact“). 3.2.4 Loading capacity The PV module‘s load resistance is rated as: Wind load: 2400 Pa / Snow load: 5400 Pa. -
Page 8: Electrical Installation And Grounding
1.25 for Short Circuit Current (Isc) and Open Circuit Figure 6B: Clamping on the short side, loading capacity scheme AEG STANDARD MODULE INSTALLATION MANUAL GD202008 V1-20... -
Page 9: Grounding
Fig. 7B Grounding Clip 3.3.3 Grounding Additional third-party grounding devices: AEG solar modules can be grounded using third-party Please refer to the respective National Electrical grounding devices. It is required that these devices are Code requirements and standards for safety-related certified for grounding solar modules and are installed grounding of racking system and/or module frames. -
Page 10: Cleaning
A mild, non-abrasive cleaning agent can be Tel: +49 (0)69400500810 used to remove stubborn dirt. High mineral content water is not recommended, as it may leave residual AEG is a registered trademark used under license from AB Electrolux (publ). AEG STANDARD MODULE INSTALLATION MANUAL GD202008 V1-20...