Servicing The Bedbar - Toro Reelmaster 5010 Series Operator's Manual
8-blade radial reel, 8-blade forward swept reel, 11-blade radial reel, or 11-blade forward swept dpa cutting unit with 7in reel
Hide thumbs
Also See for Reelmaster 5010 Series:
- Quick service reference (119 pages) ,
- Installation instructions (2 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
Figure 26
1. Bedknife (vertical)
2.
Press the Alt Zero button on the angle indicator.
3.
Place the angle-indicator mount on the edge
of the bedknife so that the edge of the magnet
mates with the edge of the bedknife
Note:
The digital display should be visible from
the same side during this step as it was in step 1.
Figure 27
1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4.
Place the angle indicator on the mount as shown
in
Figure
27.
Note:
This is the angle that your grinder
produces, and should be within 2° of the
recommended top grind angle.
g034113
2. Angle indicator
(Figure
27).
g034114
3. Bedknife
4. Angle indicator
Servicing the Bedbar
Removing the Bedbar
1.
Turn the bedbar-adjusting screws
counterclockwise to back the bedknife
away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2.
Back out the spring-tension nut, until the washer
is no longer tensioned against the bedbar
(Figure
28).
3.
On each side of the machine, loosen the locknut
securing the bedbar bolt
1. Bedbar bolt
4.
Remove each bedbar bolt allowing bedbar to
be pulled downward and removed from the
machine bolt
(Figure
Note:
Account for 2 nylon and 1 stamped steel
washer on each end of the bedbar
17
(Figure
28).
Figure 28
3. Bedbar
4. Washer
(Figure
29).
Figure 29
2. Locknut
29).
(Figure
g006498
g003334
30).
- Quick Links:
- Adjusting the Height of Cut (Hoc)
Hide quick links:
Advertisement
Table of Contents
