Maintenance; Using The Kickstand When Tipping The Cutting Unit; Lubricating The Cutting Units; Relief-Grinding The Reel - Toro Reelmaster 5010 Series Operator's Manual
8-blade radial reel, 8-blade forward swept reel, 11-blade radial reel, or 11-blade forward swept dpa cutting unit with 7in reel
Hide thumbs
Also See for Reelmaster 5010 Series:
- Quick service reference (119 pages) ,
- Installation instructions (2 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
Maintenance
Using the Kickstand when
Tipping the Cutting Unit
Whenever the cutting unit has to be tipped to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand (supplied with the traction unit) to
make sure that the nuts on the back end of the bedbar
adjusting screws are not resting on the work surface
(Figure
20).
Figure 20
1. Kickstand
Lubricating the Cutting
Units
Each cutting unit has 5 grease fittings
must be lubricated regularly with No. 2 lithium grease.
There are 2 lubrication points on the front roller, rear
roller, and 1 at the reel motor spline.
Note:
Lubricating cutting units immediately after
washing helps purge water out of the bearings
and increases bearing life.
1.
Wipe each grease fitting with a clean rag.
2.
Apply grease until clean grease comes out of
the roller seals and the bearing relief valve.
3.
Wipe any excess grease away.
Relief-Grinding the Reel
The new reel has a land width of 1.3 to 1.5 mm (0.050
to 0.060 inch) and a 30° relief grind.
When the land width gets larger than 3 mm (0.120
inch) wide, do the following:
g027160
1.
(Figure
21) that
1. 30°
14
Figure 21
Grease fitting locations on the reel motor side.
Apply a 30° relief grind on all reel blades until the
land width is 1.3 mm (0.050 inch) wide
22
and
Figure
23).
Figure 22
Radial Reels
g027174
(Figure
g028800
2. 1.3 mm (0.050 inch)
- Quick Links:
- Adjusting the Height of Cut (Hoc)
Hide quick links:
Advertisement
Table of Contents
