Xconfiguration Conference Defaultcall Rate; Xconfiguration Conference Donotdisturb Defaulttimeout; Xconfiguration Conference Encryption Mode; Xconfiguration Conference Farendcontrol Mode - Cisco TelePresence SX20 Codec Reference Manual
Application programming interface (api)
Hide thumbs
Also See for TelePresence SX20 Codec:
- Reference manual (218 pages) ,
- Administrator's manual (177 pages) ,
- User manual (88 pages)
Table of Contents
Advertisement
Cisco TelePresence SX20 Codec
Introduction
xConfiguration Conference DefaultCall Rate
Define the Default Call Rate to be used when placing calls from the system.
Requires user role: ADMIN
Default value: 3072
USAGE:
xConfiguration Conference DefaultCall Rate:
where
Rate
: Integer (64..6000)
Tthe default call rate (kbps).
xConfiguration Conference DoNotDisturb DefaultTimeout
This setting determines the default duration of a Do Not Disturb session, i.e. the period when
incoming calls are rejected and registered as missed calls. The session can be terminated
earlier by using the user interface (remote control or Touch controller). The default value is 60
minutes.
Requires user role: ADMIN
Default value: 60
USAGE:
xConfiguration Conference DoNotDisturb DefaultTimeout:
where
DefaultTimeout
: Integer (1..1440)
The number of minutes (maximum 1440 minutes = 24 hours) before the Do Not Disturb
session times out automatically.
SX20 Codec API Reference Guide CE8.1, APRIL 2016.
D15316.03
About the API
xConfiguration
xConfiguration
Rate
DefaultTimeout
xCommand
xConfiguration Conference Encryption Mode
Define the conference encryption mode. A padlock with the text "Encryption On" or
"Encryption Off" displays on screen for a few seconds when the conference starts.
NOTE: If the CE-NC software (no crypto) is installed on the video system, the encryption mode
is always Off.
Requires user role: ADMIN
Default value: BestEffort
USAGE:
xConfiguration Conference Encryption Mode:
where
Mode
: Off/On/BestEffort
Off: The system will not use encryption.
On: The system will only allow calls that are encrypted.
BestEffort: The system will use encryption whenever possible.
> In Point to point calls: If the far end system supports encryption (AES-128), the call will
be encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must
support encryption. If not, the conference will be unencrypted.
xConfiguration Conference FarEndControl Mode
Lets you decide if the remote side (far end) should be allowed to select your video sources and
control your local camera (pan, tilt, zoom).
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Conference FarEndControl Mode:
where
Mode
: Off/On
Off: The far end is not allowed to select your video sources or to control your local
camera (pan, tilt, zoom).
On: Allows the far end to be able to select your video sources and control your local
camera (pan, tilt, zoom). You will still be able to control your camera and select your
video sources as normal.
47
API Reference Guide
xStatus
Appendices
Mode
Mode
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Advertisement
Table of Contents
