Table of Contents
Advertisement
d
Hold the quilting foot in place with your right
hand, and then tighten the presser foot holder
screw using the enclosed screwdriver in your
left hand.
CAUTION
● Be sure to securely tighten the screw with the
enclosed screwdriver, otherwise the needle
may touch the presser foot, causing it to bend
or break.
e
Slide the feed dog position switch, located at
the rear of the machine on the base, to the
position shown below to lower the feed dogs.
a
a Feed dog position switch (as seen from the
rear of the machine)
Turn on the machine.
f
g
With the pattern selection dial,
select stitch
or
.
h
Use both hands to stretch the fabric taut, and
then move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of stitching.
a Pattern
• Reverse stitches cannot be sewn when the
feed dogs are lowered.
i
After sewing is finished, slide the feed dog
position switch to its original position to raise
the feed dogs.
• The feed dogs are normally left raised.
Memo
● Turn the handwheel to raise the feed dogs.
a
3
73
Advertisement
Table of Contents
