Cisco MDS 9100 Series Hardware Installation Manual page 15

Hide thumbs Also See for MDS 9100 Series:

Chapter 2

Installing the Cisco MDS 9100 Series

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Installing Cisco MDS 9100 Series Switch Rear-Facing into Cabinet

To install a Cisco MDS 9120 or 9140 Switch rear-facing into a cabinet using the rack-mount kit provided

with the switch (for cabinets with insufficient front-facing clearance), follow the steps in this section. If

you are installing a Cisco MDS 9134 Switch, Cisco MDS 9134 Switch, or a Cisco MDS 9124 Switch

rear-facing into a cabinet using the rack-mount kit provided, see

Cisco MDS 9134 Switch, or a Cisco MDS 9124 Switch Rear-Facing into Cabinet" section on page

Install the slider rails in the rack:

Step 1

Figure 2-10

OL-21514-01

Position one of the slider rails against the front rack-mounting rails and align the screw holes as

shown in

Figure

2-10. Then attach them using two 12-24 screws or two 10-32 screws, depending on

the rack rail thread type. For racks with square holes, first install the 12-24 cage nuts.

Repeat with the other slider rail on the other front side of the rack.

Use the tape measure and level to verify that the rails are horizontal and at the same height.

Installing the Slider Rails to the Front Rack-Mounting Rails

Rear cabinet

mounting

rails

Installing the Switch in a Cabinet with Insufficient Front Clearance

"Installing a Cisco MDS 9148 Switch,

Front cabinet

mounting

rails

Cisco MDS 9100 Series Hardware Installation Guide

2-17.

2-15

Table of Contents

Mds 9134 Mds 9124 Mds 9148