Cisco MDS 9100 Series Hardware Installation Manual page 7

Hide thumbs Also See for MDS 9100 Series:

Chapter 2

Installing the Cisco MDS 9100 Series

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Figure 2-1

Front rack-mount bracket

Install the slider rails in the rack. Position one of the slider rails against the rack mounting rails and align

Step 3

the screw holes as shown in

or the Cisco MDS 9124 Switch, see

Note

Attach the slider rail using two 12-24 screws or two 10-32 screws, depending on the rack rail thread type.

Step 4

For racks with square holes, insert the 12-24 cage nuts in position behind the mounting holes in the slider

rails.

Repeat with the other slider rail on the other side of the rack.

OL-21514-01

Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series

Figure

Depending on when you purchased your Cisco MDS 9124 Switch, you may have straight slider

rails like those shown in

Figure

2-3. Refer to the illustrations that show the type of rails that came with your switch.

C bracket

2-2. If you are using the notched slider rails for the Cisco MDS 9134

Figure

2-3.

2-2, or you may have the notched slider rails like those shown

Cisco MDS 9100 Series Hardware Installation Guide

Installing the Switch in a Cabinet or Rack

2-7

Table of Contents

Mds 9134 Mds 9124 Mds 9148