Table of Contents
Advertisement
Check the Running Configuration Settings
When this information appears, it means that you have successfully booted your device:
Example:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2
The first sections of the configuration script appear only at an initial system startup. On subsequent uses, the script begins
with a System Configuration Dialog as shown below. When prompted to enter the initial configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended
setup will ask you to configure each interface on the system.
The basic management setup configures enough connectivity for managing the system; the extended setup prompts you
to configure each interface on the system.
Check the Running Configuration Settings
To view the value of the settings you have entered, enter the following command in privileged EXEC mode:
device# show running-config
To review the changes you have made to the configuration, enter the following command in EXEC mode and
copy run-start stored in the NVRAM.
device# show startup-config
Save the Running Configuration to NVRAM
To store the configuration or changes to your startup configuration in NVRAM, enter the following command
at the prompt:
device# copy running-config startup-config
Cisco ASR-920-12SZ-A and Cisco ASR-920-12SZ-D Aggregation Services Router Hardware Installation Guide
62
Configure the Device
Advertisement
Table of Contents
