Lubrication; Lubricating Gear Case; Adjusting Blade Brake Cable - Toro Recycler II ProLine 21 Operator's Manual
Walk-behind power mower
Hide thumbs
Also See for Recycler II ProLine 21:
- Operator's manual (56 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
Available languages
Available languages
POTENTIAL HAZARD
A worn or damaged blade could break and
a piece of blade could be thrown into
operator's or bystander's area.
WHAT CAN HAPPEN
A thrown piece of blade could cause serious
personal injury or death to operator or
bystanders.
HOW TO AVOID THE HAZARD
Inspect blade periodically for wear or
damage.
Replace a worn or damaged blade.
5.
REMOVING BLADE—Grasp end of blade
using a rag or thickly padded glove. Remove
blade nuts, anti–scalp cup, accelerator, and blade
(Fig. 24).
6.
SHARPENING BLADE—Using a file, sharpen
top side of blade and maintain original cutting
angle (Fig. 26). The blade will remain balanced
if same amount of material is removed from both
cutting edges.
IMPORTANT: Check balance of blade by
putting it on a blade balancer. An inexpensive
balancer can be purchased at a hardware
store. A balanced blade stays in a horizontal
position and an unbalanced blade settles to
the heavy side. If blade is not balanced, file
more metal off cutting edge on heavy end of
blade.
7.
Reinstall sharp, balanced blade, blade
accelerator, anti–scalp cup, and blade nuts. Sail
part of blade must point toward top of mower
housing to assure correct installation. Tighten
blade nuts to 15–27 ft–lbs (20–37 N m).
EN–13
POTENTIAL HAZARD
Operating mower without accelerator in
place could cause blade to flex, bend or
break.
WHAT CAN HAPPEN
A broken blade could cause serious injury
or death to operator or bystanders.
HOW TO AVOID THE HAZARD
Do not operate mower without accelerator.
Lubrication
After every 25 operating hours or when season ends,
pivot arms must be lubricated.
1.
Move rear wheel height–of–cut levers to center
setting. Wipe grease fittings with clean rag
(Fig. 27). Install grease gun onto fitting and
gently apply 2 or 3 pumps of #2 Multi–Purpose
Lithium Base Grease. Excessive grease pressure
may damage seals.
Lubricating Gear Case
After every 100 operating hours, grease the gear case
with #2 Multi–Purpose Lithium Base Grease.
1.
Remove bag.
2.
Install grease gun onto fitting thru belt cover
opening (Fig. 28). Gently apply 1–2 pumps of
grease.
3.
Reinstall bag.
Adjusting Blade Brake Cable
Whenever a new blade brake cable assembly is
installed or the blade brake belt is replaced, the blade
brake cable should be adjusted.
1.
Stop engine and wait for all moving parts to
stop. Pull wire off spark plug (Fig. 12).
Advertisement
Chapters
Table of Contents
