Cleaning The Engine Cooling System; Brake Maintenance; Adjusting The Parking Brake; Servicing The Parking Brakes - Toro Reelmaster 3555 Operator's Manual
Traction unit
Hide thumbs
Also See for Reelmaster 3555:
- Operator's manual (60 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
4.
If the coolant level is low remove the expansion
tank cap, add the specified coolant to the tank
until the coolant level is midway between the
marks on the side of the tank, and assemble the
cap to the tank.
Important:
Do not overfill the expansion
tank.
5.
Close and latch the hood.
Cleaning the Engine
Cooling System
Service Interval: Before each use or daily
Remove debris from the oil cooler and radiator daily.
Clean them more frequently in dirty conditions.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Raise the hood.
3.
Clean the engine area thoroughly of all debris.
4.
Remove the lower radiator shield
Figure 72
1. Radiator
5.
Clean both sides of the radiator area thoroughly
with water or compressed air
6.
Install the lower radiator shield.
7.
Close and latch the hood.
41).
(Figure
72).
g352363
2. Lower radiator shield
(Figure
72).
Brake Maintenance
Adjusting the Parking
Brake
Service Interval: Every 200 hours—Check the
adjustment of the parking brake.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Loosen the setscrew securing the knob to the
parking-brake lever
1. Parking-brake lever
2. Knob
3.
Rotate the knob until a force of 133 to 178 N (30
to 40 lb) is required to actuate the lever.
4.
Tighten the setscrew.
Servicing the Parking
Brakes
Service Interval: Every 400 hours
Preparing the Machine
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Raise the front of machine.
3.
Support the machine with jack stands rated
for the weight of your machine; refer to
Specifications (page
4.
Repeat steps
machine.
Removing the Front Wheels
1.
Remove the 4 lug nuts that secure the front
wheel to the hub, and remove the wheel
74).
52
41).
(Figure
73).
Figure 73
3. Set screw
41).
25).
2
and
3
at the other side of the
g008923
(Figure
Hide quick links:
Advertisement
Table of Contents
