Powering Down A Line Card - Cisco Catalyst 9400 System Management Configuration Manual
Cisco ios xe bengaluru 17.4.x
Hide thumbs
Also See for Catalyst 9400:
- Hardware installation manual (192 pages) ,
- Installation note (32 pages) ,
- Troubleshooting manual (14 pages)
Table of Contents
Advertisement
Environmental Monitoring and Power Management
Step 4
Step 5
Powering Down a Line Card
If your system does not have enough power for all modules installed in the switch, you can power down one
or more line cards and place them in power-off mode.
To power down a line card, perform this task:
Procedure
Step 1
Step 2
Step 3
Command or Action
end
Example:
Device(config)# end
show power module
Example:
Device# show power module
Command or Action
configure terminal
Example:
Device# configure terminal
hw-module slot card slot/slot number
shutdown unpowered
Example:
Device(config)# hw-module slot 1/0
shutdown unpowered
end
Example:
Device(config)# end
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Powering Down a Line Card
Purpose
lowest physical slot number. Accordingly,
default configuration is as follows:
• 4-slot chassis: power supply autoLC
priority 1 4
• 7-slot chassis: power supply autoLC
priority 1 2 5 6 7
• 10-slot chassis: power supply autoLC
priority 1 2 3 4 7 8 9 10
Exits global configuration mode.
Displays power redundancy mode information,
and includes information about whether the
autoLC is enabled.
Purpose
Enters the global configuration mode.
Powers down the specified module by placing
it in low power mode.
Exits the global configuration mode
239
Advertisement
Table of Contents
Troubleshooting
