Workflow For Topology: No Connectivity To Cssm And No Cslu - Cisco Catalyst 9400 System Management Configuration Manual
Cisco ios xe bengaluru 17.4.x
Hide thumbs
Also See for Catalyst 9400:
- Hardware installation manual (192 pages) ,
- Installation note (32 pages) ,
- Troubleshooting manual (14 pages)
Table of Contents
Advertisement
Smart Licensing Using Policy
3. Product Instance Configuration
Where task is performed: Product Instance
Ensuring Network Reachability for CSLU-Initiated Communication, on page 143
4. Download All for Cisco and Upload From Cisco
Where tasks are performed: CSLU and CSSM
a.
b.
c.
Result:
You can now collect and send a RUM report to CSSM, in CSLU, by navigating to the Actions for Selected
menu, and selecting Collect Usage. If applicable the report also includes a trust code request and authorization
code request.
Since CSLU is disconnected from CSSM, you must save usage data which CSLU has collected from the
product instance to a file. Then, from a workstation that is connected to Cisco, upload it to CSSM. After this,
download the ACK from CSSM. In the workstation where CSLU is installed and connected to the product
instance, upload the file to CSLU.
In case of a change in license usage, see
Workflow for Topology: No Connectivity to CSSM and No CSLU
Since you do not have to configure connectivity to any other component, the list of tasks required to set-up
the topology is a small one. See, the Results section at the end of the workflow to know how you can complete
requisite usage reporting after you have implemented this topology.
Product Instance Configuration
Where task is performed: Product Instance
Set transport type to off.
Enter the license smart transport off command in global configuration mode. Save any changes to the
configuration file.
Device(config)# license smart transport off
Device(config)# exit
Device# copy running-config startup-config
Result:
All communication to and from the product instance is disabled. To report license usage you must save RUM
reports to a file (on your product instance) and upload it to CSSM (from a workstation that has connectivity
to the internet, and Cisco):
1. Generate and save RUM reports
Enter the license smart save usage command in privileged EXEC mode. In the example below, all RUM
reports are saved to the flash memory of the product instance, in file
file is first saved to bootflash and then copied to a TFTP location:
Download All For Cisco (CSLU Interface), on page 142
Uploading Usage Data to CSSM and Downloading an ACK, on page 159
Upload From Cisco (CSLU Interface), on page 143
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Workflow for Topology: No Connectivity to CSSM and No CSLU
Configuring a License , on page 163
to know how it affects reporting.
. In the example, the
all_rum.txt
117
Advertisement
Table of Contents
Troubleshooting
