Attaching A Chassis Ground Connection; Connecting Cables - Cisco Catalyst 8500 Series Hardware Installation Manual
Edge platforms
Hide thumbs
Also See for Catalyst 8500 Series:
- Hardware installation manual (80 pages) ,
- Regulatory compliance and safety information manual (31 pages) ,
- Deployment manual (16 pages)
Table of Contents
Advertisement
Attaching a Chassis Ground Connection
Attaching a Chassis Ground Connection
Procedure
Step 1
Use the wire stripper to strip one end of the AWG #6 wire approximately 0.75 inches (19.05 mm).
Step 2
Insert the AWG #6 wire into the open end of the grounding lug.
Figure 7: Attaching a Grounding Lug to the Chassis Ground Connector
1
2
Step 3
Use the crimping tool to carefully crimp the wire receptacle around the wire. This step is required to ensure
a proper mechanical connection.
Step 4
Locate the chassis ground connector on the side of your chassis.
Step 5
Insert the two screws through the holes in the grounding lug.
The following figure shows how to attach a grounding lug to the chassis ground connector.
Step 6
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly
to the chassis. Do not over tighten the screws.
Step 7
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an
adequate chassis ground.
Connecting Cables
Keep the following guidelines in mind when connecting any external cable to the Cisco Catalyst 8500 Series
Edge Platform:
• To reduce the chance of interference, avoid crossing high-power lines with any interface cables.
Cisco Catalyst 8500 Series Edge Platforms Hardware Installation Guide
34
Chassis ground lead wire
3
Grounding lug
4
Installing the Router
Ground screws
Chassis ground connector
holes
Hide quick links:
Advertisement
Table of Contents
