hit counter script
Toro Trans Pro 100 Installation Instructions Manual

Toro Trans Pro 100 Installation Instructions Manual

Tow-behind trailer

Advertisement

Trans Pro 100 Tow-Behind Trailer
Model No. 04240—Serial No. 310000001 and Up
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or missing.
1. Warning—do not drive the vehicle with a trailer down a hill; do
not lose control of the vehicle and trailer.
2. Warning—do not carry passengers.
1. The trailer tires should be inflated to 0.35 bar (5 psi); read
the Operator's Manual.
© 2017— The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
98-8687
Register at www.Toro.com.
98-8688
3. Warning—do not exceed 24 km/h (15 mph).
4. Warning—read the Operator's Manual; the maximum trailer
weight is 227 kg (500 lb) and the maximum tongue weight is
25 kg (55 lb).
decal98-8687
1. Warning—do not climb the ramp, you could slip and fall.
Form No. 3415-680 Rev A
Installation Instructions
98-8676
Original Instructions (EN)
All Rights Reserved *3415-680* A
Printed in the USA
decal98-8688
decal98-8676

Advertisement

Table of Contents
loading

Summary of Contents for Toro Trans Pro 100

  • Page 1 Form No. 3415-680 Rev A Trans Pro 100 Tow-Behind Trailer Model No. 04240—Serial No. 310000001 and Up Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger.
  • Page 2: Installation

    Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Trailer bed Tongue assembly Axle hub Wheel assembly Trailer ramp Bolt (3/8 x 2-3/4 inches) Spacer Assemble the trailer. Nylon Locknuts (3/8 inch) Carriage bolts (3/8 x 1 inches) Locknuts (3/8 inch) Lug nuts...
  • Page 3 Assembling the Trailer 1. Mount the tongue assembly to the mounting bracket on the underside of the trailer bed with 2 bolts (3/8 x 2-3/4 inches), 2 spacers and 2 locknuts. For most applications, use the front set of mounting holes in the tongue and bracket (Figure g012162 Figure 1...
  • Page 4: Loading The Trailer

    Loading the Trailer 4. Mount the trailer ramp to the rear of the trailer bed with the hinge rod and 2 cotter pins (Figure 1. Unhook the ramp latch from the wheel guide and lower the ramp to ground. Note: Apply a light coating of grease to the 2.
  • Page 5: Operation

    Operation • Use extreme caution and slow speed when backing up the trailer and tow vehicle. • Watch out for traffic when near or crossing roads. Operating Tips Always yield the right of way to pedestrians and other vehicles. • You can use the trailer for the Greensmaster 1000, 1010, 2000, Flex 21, 2100 and eFlex •...
  • Page 6 Notes:...
  • Page 7 Notes:...
  • Page 8 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact the Toro importer.

This manual is also suitable for:

04240

Table of Contents