Changing The Suction Filter; Changing The Pressure Filter - Toro Multi Pro 5800-G Operator's Manual
Turf sprayer with excelarate spray system
Hide thumbs
Also See for Multi Pro 5800-G:
- Operator's manual (96 pages) ,
- Software manual (36 pages) ,
- Operator's manual (104 pages)
Table of Contents
Advertisement
Changing the Suction Filter
Service Interval: Every 400 hours
Note:
Determine the appropriate suction filter mesh
size that you need for your job; refer to
Suction Filter (page
44).
1.
Park the machine on a level surface, engage the
parking brake, shut off the pump, shut off the
engine, and remove the key.
2.
At the top of the sprayer tank, remove the
retainer that secures the hose fitting attached to
the large hose from the filter housing
Figure 97
1. Suction hose
3.
Remove the hose and hose fitting from the filter
housing
(Figure
97).
4.
Remove the old suction filter from the filter
housing in the tank
Note:
Discard the old filter.
Figure 98
1. Screen vane
5.
Install the new suction filter into the filter housing.
Note:
Ensure that the filter is fully seated.
6.
Align the hose and hose fitting to the filter
housing at the top of the tank, and secure the
Selecting a
(Figure
2. Retainer
(Figure
98).
2. Suction filter
fitting and housing with the retainer that you
removed in step 2.
Changing the Pressure
Filter
Service Interval: Every 400 hours
1.
Move the machine to a level surface, shut off the
spray pump, shut off the engine, and remove
the key.
2.
Align a drain pan under the pressure filter
97).
(Figure
99).
g033577
1. Filter head
2. O-ring (bowl)
3. Filter element
3.
Rotate the drain plug counterclockwise and
remove it from the bowl of the pressure filter
(Figure
99).
Note:
Allow the bowl to drain completely.
4.
Rotate the bowl counterclockwise and remove it
from its filter head
5.
Remove the old pressure-filter element
99).
Note:
Discard the old filter.
6.
Check the O-ring for the drain plug (located
inside the bowl) and the O-ring for the bowl
g033578
(located inside the filter head) for damage and
wear
(Figure
Note:
Replace any damaged or worn O-rings
for the plug, bowl, or both.
7.
Install the new pressure-filter element into the
filter head
Note:
Ensure that the filter element is firmly
seated into the filter head.
73
Figure 99
4. Bowl
5. O-ring (drain plug)
6. Drain plug
(Figure
99).
99).
(Figure
99).
g028235
(Figure
Advertisement
Table of Contents
