Table of Contents
Advertisement
Step
Step 2
Step 3
Step 4
Step 5
Step 6
4.4.1.2
Joe's Phone Configuration
The following steps are used to configure line 1 for Joe's phone. This line rings when Joe
is called, and it has Joe's authentication information.
Step
Subscriber configuration file: <MACaddress>-ext.cfg
Step 1
Step 2
Step 3
BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK 84XX SERIES
©
2018 BROADSOFT INC.
Command
Configure the line label.
Example:
reg.2.label="Joe"
Configure the Registration User ID.
Example:
reg.2.address="2405551111_2"
Configure the SIP Digest Authentication
User ID.
Example:
reg.2.auth.userID="joebrown"
Configure the SIP Digest Authentication
Password.
Example:
reg.2.auth.password="joeb"
(Optional) Enable Barge-In.
Example:
reg.2.bargeInEnabled="1"
Command
Configure the line as shared.
Example:
reg.1.type="shared"
Configure the line label.
Example:
reg.1.label="Joe"
Configure the Registration User ID.
Example:
reg.1.address="240555222_1"
Purpose
The label is displayed next to the line
key.
This is the register user ID, which is
used to register Bob's line2 with
BroadWorks.
This should match the SCA line/port
field on Joe's Shared Call
Appearance page.
This is the SIP Digest Authentication
User ID. If the Authentication service is
configured on BroadWorks, then the
Digest Auth User ID parameters must be
configured to match the BroadWorks
settings.
This line rings when Joe is called, and
so it has Joe's Authentication
information.
This is the SIP Digest Authentication
Password. If the Authentication service
is configured on BroadWorks, then the
Digest Auth Password parameters must
be configured to match the BroadWorks
settings.
This line rings when Joe is called, and
so it has Joe's Authentication
information.
(Optional) enable the line for barge-in
attempts on active Shared Call
Appearance calls.
Purpose
Configure the line as "shared" (as
opposed to "private").
The label is displayed next to the line
key.
This is the register user ID, which is
used to register Joe's line 1 with
BroadWorks.
The register user ID must correspond
with the line/port setting on
BroadWorks.
20-BD5605-00
PAGE 24 OF 34
Hide quick links:
Advertisement
Table of Contents
