Contents For the user Important safety information Care and cleaning - General cleaning - Rinse aid dispenser - Spray arm - Coarse filter - Fine filter - Detergent dispenser - Water softener - Water softener plug - Cleaning the cabinet The control panel and programmes 6 How to load the dishwasher -Instruction for test centres...
Important safety information Before installing and first using the dishwasher, read the instruction booklet carefully, including its hints and warnings. Doing so will ensure that your machine will perform properly and to best advantage. Anyone using the machine should be thoroughly familiar with its instructions for use and safety features.
Care and cleaning Important Make sure that the machine is unplugged and the water turned off before undertaking any kind of maintenance. General cleaning Inspect the filters and spray arm nozzle before re-loading the machine and remove any food scraps. Wipe round the rubber gasket at the bottom of the door to remove grease which tends to collect there.
Since not all detergents are the same, you should also consult the instructions on the packet. Using the correct amount of detergent also contributes to reducing pollution. Zanussi recommends the use of Finish dish- washer detergent and Rinse Aid. Water softener (6)
The control panel and programmes On/Off-button Press the button in order to start the required programme. Temperature selector 55° - Button in 65° - Button out Extra drying effect If the button is pressed in the temperature of the final rinse water will be higher and the drying effect will be improved.
How to load the dishwasher The illustration shows the machine loaded with five stan- dard place settings. Your own dishes are not likely to be identical to this load, but if you follow the advice below we are sure you will be pleased with the results. •...
Using your appliance Proceed as follows: 1. Scrape off solid food remnants. 2. Load the dishwasher. (See “How to load the dishwasher”). Pour approx. 15 g detergent into the detergent dispenser and close the dispenser lid. If the dishes are heavily soiled add an extra 5 g anywhere on the inside of the door.
In the event of a fault Before calling out an engineer, please check through the details below because some faults can be rectified easily without the need to call out an engineer. If an engineer is called to resolve a problem listed below or to repair a fault caused by incorrect installation or mis-use a charge will be made, even if the appliance is under guarantee.
Please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls. Customer Care Department For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi.co.uk...
Standard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of the purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •...
Installation instructions Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. Technical specifications Dimensions Weight...
Unpacking the machine If the machine is damaged If the dishwasher has been damaged during transport, you should immediately notify the company responsible for delivering it. Check that the dishwasher is undamaged. If you discover any damage, faults or that anything is missing, you should notify the dealer immediately.
Installation The dishwasher is intended for installation on a kitchen sink or worktop. It is important to ensure the dishwasher is level to avoid any difficulty opening and closing the door. Its height can be adjusted with the adjustable feet (8 mm each) in each corner of the dishwasher.
Page 15
Power supply The dishwasher is supplied with a lead and electrical plug for connection to a 230 V, 13 A earthed wall socket. Before any work is carried out on the dishwasher, it must be isolated from the electric mains supply, for example by removing the plug from the wall socket.