Table of Contents
Advertisement
Figure 4
3
2E
W1
2W
1
Step 4
Step 5
Step 6
Warning
and reinstate power by moving the handle of the circuit breaker to the ON position. (To see translated
versions of this warning, refer to the Regulatory Compliance and Safety Information document that
accompanied the router.)
Blank Network Module Panels
If the router is configured with fewer than four network modules, make sure that blank panels fill the
open chassis slots to provide proper airflow. (See Figure 5.)
Figure 5
Installing a Module in a Router
B1
BRI
B2
NT1
SEE MANUAL BEFORE INSTALLATION
2E
2W
ETHERNET 1
ETHERNET 0
Push the module into place until you feel its edge connector mate securely with the
connector on the motherboard.
Fasten the module's captive mounting screws into the holes in the chassis, using the
Phillips or flat-blade screwdriver.
If the router was previously running, reinstall the network interface cables and turn ON
power to the router.
The following warning applies to routers that use a DC power supply:
After wiring the DC power supply, remove the tape from the circuit breaker switch handle
Blank Network Module Panel
Installing a 2-Slot Network Module in a Chassis Slot
Router
WO
SERIAL
W1
DO NOT INSTALL WAN INTERFACE
AUI
B1
CARDS WITH POWER APPLIED
EN
BRI
B2
S/T
ETHERNET 1
ETHERNET 0
Module
WAN Card Slot Network Module Configuration Note
2
0
WO
INPUT 100-240V AC 50/60HZ 3.0-1.5 AMPS
AUI
EN
7
Advertisement
Table of Contents
