Table of Contents
Advertisement
This document contains the following sections:
•
Software Requirements, page 3
•
Safety Recommendations, page 3
•
Required Tools and Equipment, page 6
•
•
Network Module Connectors, page 8
•
Connecting Ethernet Ports, page 10
•
Connecting Token Ring Ports, page 13
•
WAN Card Slot Module LEDs, page 14
•
•
Obtaining Service and Support, page 21
•
Cisco Connection Online, page 21
Warning
equipment. (To see translated versions of this warning, refer to the Regulatory Compliance and
Safety Information document that accompanied the router.)
Warning
AC units; disconnect the power at the circuit breaker on DC units. (To see translated versions of this
warning, refer to the Regulatory Compliance and Safety Information document that accompanied the
router.)
Warning
regulations. (To see translated versions of this warning, refer to the Regulatory Compliance and
Safety Information document that accompanied the router.)
Caution
have discharged all static electricity from your body before opening the chassis. Before performing
procedures described in this document, review the section "Safety Recommendations" later in this
document.
Software Requirements
The minimum version of Cisco Internetwork Operating System (Cisco IOS) software needed for
2-slot network modules is 11.1(6)AAS.
Safety Recommendations
Follow these guidelines to ensure general safety:
•
Keep the chassis area clear and dust-free during and after installation.
•
Put the removed chassis cover in a safe place.
•
Keep tools away from walk areas where you or others could fall over them.
Only trained and qualified personnel should be allowed to install or replace this
Before working on a chassis or working near power supplies, unplug the power cord on
Ultimate disposal of this product should be handled according to all national laws and
To avoid damaging electrostatic discharge (ESD)-sensitive components, ensure that you
WAN Card Slot Network Module Configuration Note
Software Requirements
3
Advertisement
Table of Contents
