Cisco 7941G Administration Manual page 13

Unified communications manager 9.0 (sccp and sip)

Hide thumbs Also See for 7941G:

Table of Contents

Cisco Unified IP Phones Installation

See the following figure for a graphical overview of the phone parts.

Figure 3: Parts Used to Wall Mount the Cisco Unified IP Phone

Before You Begin

To ensure that the handset attaches securely to a wall-mounted phone, remove the handset wall hook from

the handset rest, rotate the hook 180 degrees, and reinsert the hook. Turning the hook exposes a lip on which

the handset catches when the phone is vertical. For an illustrated procedure, see Installing the Wall Mount

Kit for the Cisco Unified IP Phone at:

http://www.cisco.com/en/US/products/hw/phones/ps379/prod_installation_guides_list.html

Use care not to damage wires or pipes located inside the wall when securing screws to wall studs.

Caution

Procedure

Step 1

Push in the footstand adjustment button.

Step 2

Adjust the footstand, so it is flat against the back of the phone.

Step 3

Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand.

The keyholes fit standard phone jack mounts.

Step 4

Hang the phone on the wall.

Footstand adjustment button: Raises and lowers adjustment plate

Wall mounting screw holes

Adjustment plate: Raises and lowers phone vertically

Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified

Mount Phone on Wall

Communications Manager 9.0 (SCCP and SIP)

Table of Contents

7941g-ge 7942g 7961g 7961g-ge 7962g