Advertisement
Quick Links
Thin Twin
WasheriDryer
230 Volt, 50 Hz
In Sk rllation
sfrucfions
IMPORTANT:
Read
and save
these instructions,
IMPORTANt
Insbller:
Leave Installation
Instruct'-
-
with the homeowner,
Ions
Homeowner:
Keep Installation lnstr
for
future reference,
uctions
Save Installation Instructions for locc
electrical inspector's use. 31
I
Advertisement
Related Manuals for Whirlpool 50 Hz
Summary of Contents for Whirlpool 50 Hz
- Page 1 Read these instructions, IMPORTANt Insbller: Leave Installation Instruct’- Ions with the homeowner, Homeowner: Keep Installation lnstr uctions future reference, Save Installation Instructions for locc electrical inspector’s use. 31 Thin Twin WasheriDryer 230 Volt, 50 Hz In Sk rllation sfrucfions...
-
Page 2: Electrical Requirements
Before you start... Check locatlon where washer/dryer will be installed. Proper installation is your responsibility. The washer/dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Make sure vou have evervthina necessarv correct installation. - Page 3 Exhaust reauirements Fire Hazard . Do Not use non-metal, tlexlble duct. Do Not use metal duct smaller than 4 Inches (10.2 cm) In diameter. . Do Not use exhaust hoods wlth magnetic latches. Check that exhaust system Is not longer than specltled.
- Page 4 1 Insert a rear- leveling leg into the hole in the rear corner on the bottom of the washer/dryer. Push leg in until it snaps into place. the same same thing with the other leveling leg in the other rear corner. Push up one leg: check to see that the...
- Page 5 Numbers correspond to steps. IMPORTANT: THIS PROCEDURE MUST BE FOLLOWED TO ASSURE PkOPER INSTALLATION. clamp l/4” dra\in (drain hose (.64 cm) connector WICIX. n To prevent the drain hose from coming off or leaking, it must be installed per the following instructions: 1.
-
Page 6: Recessed And Closet Installation Instructions
Determine the length exhaust duct that is needed to-connect dryer to the exhaust hood. See “Exhaust requirements,” Panel B. Connz Ghaust ’ duct to washer/dryer and then to the exhaust hood. Use the straightest path possible to avoid 90” turns. Use duct tape seal joints in the... - Page 7 Check that dryer ‘START” button has been firmly pushed. Part No. 3397516 01995 Whirlpool Corporation Prepared by Whirlpool Corporation, If you need assistance... Call your dealer or local authorized service company. When you call, you will need the washer/dryer...