15.12 Installing The Switchgear Termination - Siemens NXPLUS C Installation And Operating Instructions Manual
Medium-voltage switchgear, fixed-mounted circuit-breaker switchgear up to 24 kv, extendable, single busbar, metal-enclosed, gas-insulated
Hide thumbs
Also See for NXPLUS C:
- Installation and operating instructions manual (172 pages) ,
- Installation and operating instructions manual (266 pages)
Table of Contents
Advertisement
802-9081.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • Revision 11
15.12 Installing the switchgear termination
The end panel of the NXPLUS C switchgear is delivered as standard with pre-assembled
switchgear termination and termination angle.
If the customer ordered without pre-assembled switchgear termination and termination
angle, perform the following work operations.
➭ Bolt the switchgear termination together with the front and rear edge of the end panel
using 12 self-tapping bolts size M5 each.
➭ Mount the termination angle at the upper edge of the panel.
➭ In panels without pressure relief duct, press the end cover firmly to the wall and tighten the
bolts. If applicable, fasten to the wall.
INFORMATION
Installation
143/293
Advertisement
Table of Contents
