Removing And Installing Components - Cisco MDS 9396S Installing

Hide thumbs Also See for MDS 9396S:

Table of Contents

Installing the Cisco MDS 9396S Switch

• Recommended power cable for your nation or region

• AC power source with the required amperage located within reach of the power cable being used

Step 1

Connect a power supply to an AC power source as follows:

a. Using the recommended power cable for your country or region (see the

connect the C19 plug on the power cable to the power receptacle on the power supply.

b. Connect the other end of the power cable to the AC power source.

c. Verify that the LED is on and green. If the LED is off, check the AC power source circuit breaker to be sure that it

is turned on.

Step 2

If you are using the power supply (n+1) redundancy, you must connect the second power supply as follows:

a. Using the recommended power cable for your country or region (see the

connect the C19 plug on the power cable to the power receptacle on the second power supply.

b. Connect the other end of the power cable to the AC power source used by the other power supply.

c. Verify that the LED is on and green. If the LED is off, check the AC power source circuit breaker to be sure that it

is turned on.

Step 3

If you are using the grid (n+n) redundancy, you must connect the second power supply as follows:

a. Using the recommended power cable for your country or region (see the

connect the C19 plug on the power cable to the power receptacle on the second power supply.

b. Connect the other end of the power cable to a second AC power source (this is a different power source than the one

used by the first power supply).

c. Verify that the LED is on and green. If the LED is off, check the AC power source circuit breaker to be sure that it

is turned on.

Removing and Installing Components

The Cisco MDS 9396S switch is shipped with two field replaceable power supplies. Each power supply

includes a fixed fan. The Cisco MDS 9396S switch has two field-replaceable fan modules.

Warning

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution

when servicing. Statement 1034

Caution

During this procedure, wear grounding wrist straps to avoid ESD damage to the switch.

Removing and Installing Components

Supported Power Cords and Plugs

Installing the Cisco MDS 9396S Switch

section),

Table of Contents