Table of Contents
Advertisement
Quality of Service
QoS Advanced Mode
STEP 5
STEP 6
STEP 7
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
-
Traffic flows on interfaces, to which policy is applied that do not match the
Mirrored class map classification, will follow the default policy default action.
•
Police Type—Select the policer type for the policy. The options are:
-
None—No policy is used.
-
Single—The policer for the policy is a single policer.
-
Aggregate—The policer for the policy is an aggregate policer.
If Police Type is Aggregate, select the Aggregate Policer.
If Police Type is Single, enter the following QoS parameters:
•
Ingress Committed Information Rate (CIR)—Enter the CIR in Kbps. See a
description of this in the Bandwidth page.
•
Ingress Committed Burst Size (CBS)—Enter the CBS in bytes. See a description of
this in the Bandwidth page.
•
Exceed Action—Select the action assigned to incoming packets exceeding the CIR.
The options are:
-
Drop—Packets exceeding the defined CIR value are dropped.
-
Out of Profile DSCP—IP packets exceeding the defined CIR are forwarding with a
new DSCP derived from the Out Of Profile DSCP Mapping Table.
•
Peak Enforcement—Select to enable action if peak burst size is exceeded.
•
Peak Information Rate (PIR)—Enter the peak traffic rate (PIR) in kbits per second
(kbps).
•
Peak Burst Size (PBS)—Enter the peak burst size (PIR) in kbits per second (kbps).
•
Violate Action—Select one of the following actions if peak size is exceeded:.
-
Drop—Drop the frames violating the peak size.
-
Out-of-Profile DSCP—Mark frames violating the peak size with the DSCP value
with previously-set DSCP value.
Click Apply.
20
374
Hide quick links:
Advertisement
Table of Contents
