Smartport
Configuring Smartport Using The Web-based Interface
STEP 1
STEP 2
STEP 3
NOTE
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
To apply a Smartport macro:
Click Smartport > Interface Settings.
To reapply the last Smartport macros that was associated with a group of interfaces, click one
of the following options:
-
All Switches, Routers and Wireless Access Points—Reapplies the macros to all
interfaces.
-
All Switches—Reapplies the macros to all interfaces defined as switches.
-
All Routers —Reapplies the macros to all interfaces defined as routers.
-
All Wireless Access Points—Reapplies the macros to all interfaces defined as
access points.
To reapply the Smartport macros associated with a specific interface, select that
interface (it must be UP) and click Reapply to reapply the last macro that was applied
to the interface.
The Reapply action also adds the interface to all newly-created VLANs.
Smartport Diagnostic.
If a Smartport macro fails, the Smartport Type of the interface is Unknown. Select an interface
which is of unknown type and click Show Diagnostic. This displays the command at which
application of the macro failed. See the workflow area in
troubleshooting tips. Proceed to reapply the macro after correcting the problem.
Resetting all Unknown interfaces to Default type.
•
Select the Smartport Type equals to checkbox.
•
Select Unknown.
•
Click Go.
•
Click Reset All Unknown Smartports. Then reapply the macro as described above.
This performs a reset on all interfaces with type Unknown, meaning that all interfaces
are returned to the Default type. After correcting the error in the macro or on the current
interface configuration or both, a new macro may be applied.
Resetting the interface of unknown type does not reset the configuration performed by the
macro that failed. This clean up must be done manually.
To assign a Smartport type to an interface or activate Auto Smartport on the interface:
Common Smartport Tasks
10
section for
188