Running Express Setup - Cisco Catalyst 3850 Getting Started Manual
Hide thumbs
Also See for Catalyst 3850:
- Hardware installation manual (146 pages) ,
- Manual (120 pages) ,
- Deployment manual (54 pages)
Table of Contents
Advertisement
Running Express Setup
Use Express Setup to enter the initial IP information. This action enables the switch to connect to local
routers and the Internet. You can access the switch through the IP address for further configuration.
To use the CLI-based initial setup program, see Appendix C, "Configuring the Switch with the
Note
CLI-Based Setup Program," in the switch hardware guide.
You need this equipment:
•
•
•
Before running Express Setup, disable any pop-up blockers or proxy settings in your browser and any
Note
wireless client running on your PC or laptop.
Step 1
Make sure that nothing is connected to the switch.
Step 2
During Express Setup, the switch acts as a DHCP server. If your PC or laptop has a static IP address, temporarily
change your PC or laptop settings before you use DHCP.
Write down the static IP address. You will need this IP address in
Note
Step 3
Install the power supply modules. See the "Power Supply Installation" chapter in the Catalyst 3850 Switch Hardware
Installation Guide for instructions.
http://www.cisco.com/go/cat3850_hw
OL-26778-02
PC or laptop with Windows Vista, XP, or 2000
Browser (Internet Explorer 5.5, 6.0, 7.0, Firefox 1.5, 2.0, and 3.0) with JavaScript enabled
Straight-through or crossover Category 5 Ethernet cable
ACTV
Step
14.
Catalyst 3850 Switch Getting Started Guide
Running Express Setup
3
- Quick Links:
- Running Express Setup
Hide quick links:
Advertisement
Table of Contents
