Table of Contents
Advertisement
Chassis-Lifting Guidelines
Chassis-Lifting Guidelines
The chassis is not intended to be moved frequently. Before you install the system, ensure that your site is
properly prepared so that you can avoid having to move the chassis later to accommodate power sources and
network connections.
Each time you lift the chassis, follow these guidelines:
• Ensure that your footing is solid, and balance the weight of the chassis between your feet.
• Lift the chassis slowly; never move suddenly or twist your body as you lift.
• Keep your back straight and lift with your legs, not your back. If you must bend down to lift the chassis,
• Do not remove installed components from the chassis.
• Always disconnect all external cables before lifting or moving the chassis.
Warning
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles
on modules (such as power supplies, fans, or cards); these types of handles are not designed to support the
weight of the unit. Lift the unit only by using handles that are an integral part of the chassis, or by grasping
the chassis underneath its lower edge. Statement 163
Tools and Equipment
You need the following tools and equipment to install and upgrade the router and its components:
• ESD-preventive cord and wrist strap
• Antistatic mat or antistatic foam
• Number 1 and Number 2 Phillips-head screwdrivers
• Flat-blade screwdrivers: Small 3/16-inch (0.476 cm) and medium 1/4-inch (0.625 cm):
• #12-24 pan-head screws to secure the router to the equipment rack
• Cables for connecting to the WAN and LAN ports (depending on the configuration)
• Ethernet hub or switch or PC with a network interface card for connecting to the Ethernet ports
• Console terminal (an ASCII terminal or a PC running terminal emulation software) that is configured
• Console cable for connecting to the console port
• (Optional) Modem for connecting to the auxiliary port for remote administrative access
Cisco NCS 560-4 Router Hardware Installation Guide
36
bend at the knees, not at the waist, to reduce the strain on your back muscles.
• To install or remove modules
• To remove the cover if you are upgrading the memory or other components
for 9600 baud, 8 data bits, no parity, and two stop bits
Preparing for Installation
Hide quick links:
Advertisement
Table of Contents
