hit counter script
  1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Network Router
  5. ASR 1000 Series
  6. Replacing

Cisco ASR 1000 Series Replacing page 60

Removing and replacing frus from the routers
Hide thumbs Also See for ASR 1000 Series:
Table of Contents

Advertisement

Replacing the AC Power Supply in Cisco ASR 1006 Router
3
4
*For information about the DB-25 alarm
connector, how it works, and Cisco ASR 1000
series route processor LEDs, see xref "How Cisco
ASR1000-RP Alarm Monitoring Works" section
on page 2-20.
Note: Shielded cables must be used to connect to
the DB-25 alarm connector on both the AC and
DC power supplies, in order to comply with
FCC/EN55022/CISPR22 Class A emissions
requirements.
The following figure shows the ASR1013/06-PWR-AC power supply of the Cisco ASR 1006 Router.
1
AC power supply fan
2
DB-25 alarm connector
3
Tie-wrap tab
4
AC power supply captive screw
5
AC power supply handle
SUMMARY STEPS
1. Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.
2. Tighten the captive screws.
3. Insert the AC power cable.
4. Plug the power supply cable into the power source.
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
60
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Cable tie-wrap tabs
AC power supply
captive screws
6
AC power inlet
7
AC power supply Standby switch
8
Protective shielding on both sides of the Standby switch
9
AC power supply LEDs
—
—
7
AC power supply Standby
switch. A Standby switch is
not considered a disconnect.
8
AC power supply LEDs

Advertisement

Table of Contents
loading

Related Manuals for Cisco ASR 1000 Series

Related Products for Cisco ASR 1000 Series

This manual is also suitable for:

Asr 1002Asr 1002-fAsr 1006Asr 1013Asr 1002-rp1Asr 1002-rp2 ... Show all

Table of Contents