Toro Groundsmaster 360 Installation Instructions
Differential lock kit, 2-wheel drive multi-purpose machine
Hide thumbs
Also See for Groundsmaster 360:
- Service manual (497 pages) ,
- Operator's manual (72 pages) ,
- Installation instructions manual (8 pages)
Advertisement
Quick Links
Differential Lock Kit
Groundsmaster
Model No. 30508
This product contains a chemical or chemicals known to the State of California to
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface, lower the deck,
engage the parking brake, shut off the engine, and
remove the key from the ignition switch.
2. Disconnect the negative cable from the battery post;
refer to the Operator's Manual for your machine.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
360 2-Wheel Drive Multi-Purpose Machine
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
No parts required
Mount plate
Carriage screw (3/8 x 1 inch)
Flange nut (3/8 inch)
90° fitting
Differential lock valve
Screw (1/4 x 2 inches)
Flange nut (1/4 inch)
Hose
Switch
Wire harness
No parts required
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
1
2
2
1
1
2
2
1
1
1
–
WARNING
Incorrect battery cable routing could damage
the machine and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
3. Disconnect the positive cable from the battery post;
refer to the Operator's Manual for your machine.
Form No. 3406-541 Rev A
Installation Instructions
Use
Prepare the machine.
Install the kit.
Install the switch.
Complete the installation.
Original Instructions (EN)
All Rights Reserved *3406-541* A
Printed in the USA
Advertisement
Related Manuals for Toro Groundsmaster 360
Summary of Contents for Toro Groundsmaster 360
- Page 1 2. Disconnect the negative cable from the battery post; refer to the Operator’s Manual for your machine. refer to the Operator’s Manual for your machine. © 2016—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3406-541* A...
- Page 2 Installing the Differential Lock Parts needed for this procedure: Mount plate Carriage screw (3/8 x 1 inch) Flange nut (3/8 inch) 90° fitting Differential lock valve Screw (1/4 x 2 inches) Flange nut (1/4 inch) Hose Figure 1 Procedure 1. Frame member 5.
- Page 3 8. Install the female end of the new hose to the 90° fitting on the right side of the transmission (Figure Installing the Switch Parts needed for this procedure: Switch Wire harness Procedure 1. Remove the plug from the control panel to expose the switch-mounting hole (Figure 2.
- Page 4 Figure 4 1. Seat plate 3. New wire harness Figure 6 2. Control panel 1. Harness connector 2. Harness clip 6. Install the control panel with the button-head screws 9. Disengage the seat latch and lower the seat. previously removed. 10.