Cisco IE 3010 Installation Instructions Manual page 20

Hide thumbs Also See for IE 3010:

Table of Contents

Switch Installation

Installing and Removing SFP Modules

Caution:

When you use commercial SFP modules such as CWDM and 1000BX-U/D, reduce the maximum operating

temperature by 59°F (15°C). The minimum operating temperature is 32°F (0°C).

Caution:

To prevent electrostatic-discharge (ESD) damage, follow standard board and component handling

procedures.

Warning:

Do not insert and remove SFP modules while power is on; an electrical arc can occur. This could cause an

explosion in hazardous location installations. Be sure that power is removed or the area is nonhazardous before

proceeding. Statement 1087

Note:

Removing and installing an SFP module can shorten its useful life. Do not remove and insert any module more often

than is absolutely necessary.

Figure 28 on page 40

Caution:

Do not install or remove the LC SFP module with fiber-optic cables attached because of potential damage

to the cables, the cable connector, or the optical interfaces in the SFP module. Disconnect all cables before

removing or installing an SFP module. Removing and installing an SFP module can shorten its useful life. Do not

remove and insert SFP modules more often than is absolutely necessary.

Installing Fiber Optic SFP Modules

Warning:

Class 1 laser product. Statement 1008

To install and cable an optical SFP transceiver uplink port:

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.

Find the send (TX) and receive (RX) markings on the module top.

On some SFP modules, the send and receive (TX and RX) markings might be replaced by arrows that show the direction

of the connection, either send or receive (TX or RX).

If the module has a bale-clasp latch, move it to the open, unlocked position.

Align the module in front of the slot opening, and push until you feel the connector snap into place.

If the module has a bale-clasp latch, close it.

For fiber-optic SFP modules, remove the dust plugs and save.

Connect the SFP cables.

shows an LC SFP module with a bale-clasp latch.

Table of Contents