Jacking Instructions - Toro Groundsmaster 4500-D Series Service Manual
Hide thumbs
Also See for Groundsmaster 4500-D Series:
- Service manual (347 pages) ,
- Operator's manual (92 pages) ,
- Installation instructions manual (28 pages)
Table of Contents
Advertisement
Jacking Instructions
Jacking the Front End
Groundsmaster
®
4500-D/4700-D
19245SL Rev A
When changing attachments, tires or performing other service, use
correct jacks and supports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to raising machine,
remove any attachments that may interfere with the safe and proper
raising of the machine. Always chock or block wheels. Use jack
stands to support the raised machine. If the machine is not properly
supported by jack stands, the machine may move or fall, which may
result in personal injury.
g036670
1. Apply parking brake and chock both rear tires to prevent the machine from
moving.
Note: Do not place jack, jack stands or blocks under the wheel motors.
Wheel motors can be damaged if used for jacking or support points.
2. Position jack securely under the frame, just to the inside of the front tire.
3. Jack front wheel off the ground.
4. Position appropriate jack stands under the frame as close to the wheel as
possible to support the machine.
CAUTION
Figure 1
Page 1–7
Safety: Safety Instructions
- Quick Links:
- Machine Fault Codes
Hide quick links:
Advertisement
Chapters
Table of Contents
