Cisco NCS 5500 Series Hardware Installation Manual page 139
Modular routers
Hide thumbs
Also See for NCS 5500 Series:
- Configuration manuals (268 pages) ,
- Configuration manual (172 pages) ,
- Manual (25 pages)
Table of Contents
Advertisement
LEDs
4
Table 11: Route Processor Card LED Descriptions
LED
ATTN (Attention)
STS (Status)
ACT (Active)
Management port
LINK
Management port
ACT
1588 port LINK
(NC55-RP-E only)
1588 port ACT
(NC55-RP-E only)
Management port link and
active LEDs
Color
Status
Flashing blue
The operator has activated this LED to identify this module in the
chassis.
Off
This module is not being identified.
Green
This module is operational.
Flashing
The module is booting up or shutting down.
amber
Flashing red
The module has active major or critical alarms.
Amber
Host kernel booted and is ready to start System Administrator VM.
Red
Either of the following conditions:
• The module has detected a slot ID parity error and will not power
on or boot up.
• The module is not fully inserted.
Off
The module is not receiving power.
XR VM is operational and is in the active redundancy role on this
Green
module.
Amber
XR VM is operational and is in the standby redundancy role on this
module.
Off
XR VM is not operational on this module.
The management port is linked up.
Green
Off
The management port is not linked up.
Flashing green
The management port is transmitting or receiving.
Off
The management port is not transmitting or receiving.
The 1588 port is linked up.
Green
Off
The 1588 port is not linked up.
Flashing green
The 1588 port is transmitting or receiving.
Off
The 1588 port is not transmitting or receiving.
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
LEDs
133
Hide quick links:
Advertisement
Table of Contents
