Transceivers, Connectors, And Cables; Transceiver And Cable Specifications; Rj-45 Connectors; Pinouts - Cisco NCS 5500 Series Hardware Installation Manual
Modular routers
Hide thumbs
Also See for NCS 5500 Series:
- Configuration manuals (268 pages) ,
- Configuration manual (172 pages) ,
- Manual (25 pages)
Table of Contents
Advertisement
Transceivers, Connectors, and Cables
Transceivers, Connectors, and Cables
Transceiver and Cable Specifications
To determine which transceivers and cables are supported by this router, refer to the Transceiver Module
Group (TMG) Compatibility Matrix Tool:
https://tmgmatrix.cisco.com/home
To see the transceiver specifications and installation information, see
Upgrade
RJ-45 Connectors
The RJ-45 connector connects Category 3, Category 5, Category 5e, Category 6, or Category 6A foil twisted-pair
or unshielded twisted-pair cable from the external network to the following module interface connectors:
• Router chassis
Caution
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair
(FTP) cable that is properly grounded at both ends.
The following figure shows the RJ-45 connector.
Figure 2: RJ-45 Connector
1
Pinouts
The following sections describe the pinouts for the Cisco NCS 5500 RP-E (NC55-RP-E) interfaces:
BITS Port Pinouts
The table below summarizes the BITS port pinouts.
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
12
Guides.
• CONSOLE port
• MGMT ETH port
Pin 1
NCS 5500 Series Modular Router Overview
Cisco Transceiver Modules Install and
2
Pin 2
Hide quick links:
Advertisement
Table of Contents
