Advertisement
Quick Links
s
LCD Remote keypad
SAK 51 / 52
Installation instructions
Fig. 1
Fig. 2
r
Y
T
w
Fig. 3
Q
W
e
E
R
U
I
O
P
{
}
q
1. Product description
The SAK 51 and SAK 52 remote keypads are used to operate
and program the central control units. The SAK 52 also has a
speaker and microphone for audio verification.
2. Supply package
The SAK 51 and SAK 52 supply packages contain the
following,
- One SAK 51 or SAK 52 remote keypad.
- One SLK 51/52 language kit with:
- installation instructions,
- operating instructions,
- one plastic front.
3. Mounting instructions
The SAK 51 and SAK 52 are designed for mounting in dry
indoor rooms. They must not be exposed to dripping or
splashing water.
Avoid touching and spilling any dust on the contact of the
keyboard.
3.1 Secure plastic front (fig. 1)
1 - Peel back the backing foil Q half way.
2 - Place the plastic front W in the recess.
3 - Stick down the plastic front in the recess whilst peeling
away the remaining backing foil.
3.2 Open housing (fig. 2)
1 - Release both locking tabs (A) and remove top section (B).
3.3 Product overview (fig. 3)
- Q Mounting base,
- W Circuit board SMK 51,
- E Jumper for the microphone sensitivity,
- R Jumper for speaker volume,
- T Tamper contact,
- Y Jumper for the Buzzer
- U Cover of the Keypad,
- I Speaker
- O Mounting holes,
- P Cable inlet,
- { Cable clip,
- } Back tamper contact screw,
- q E-Bus connection,
- w Audio connection,
- e Potentiometer for LED display,
- r Potentiometer for buzzer volume.
3.4 Fit housing (fig. 3)
1 - Pull the cable through the cable inlet P .
2 - Secure the mounting base O using two screws.
3 - Use the cable clip { .
Advertisement
Related Manuals for Siemens SAK 51
Summary of Contents for Siemens SAK 51
- Page 1 SAK 51 / 52 Installation instructions 1. Product description The SAK 51 and SAK 52 remote keypads are used to operate and program the central control units. The SAK 52 also has a speaker and microphone for audio verification. 2. Supply package...
- Page 2 4. Wiring 4.1 E-Bus (fig. 4) The E-Bus (B4+,B3,B2,B1-) must be connected to the central control panel (A) and also to other accessories (B). For additional information see the Control panel installation manual 4.2 Audio for SAK 52 (fig. 5) Connect terminals A- and A+ to the central control unit (E) (e.g.