Advertisement
Table of Contents
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Safety Markings/Symbols
Read
Do Not
Instructions
Expose To
Before
Rain.
Use.
IMPORTANT: To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all products and on
engines.
1.1
PERSONAL PRECAUTIONS
Use in a well ventilated area.
Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working near a
lead-acid battery.
Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean
running water for at least 15 minutes and seek immediate medical attention.
Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current
high enough to weld a ring or the like to metal, which may cause severe burns.
1.2
IMPORTANT SAFETY INSTRUCTIONS
Familiarise yourself with the applications, limitations and potential hazards of the RoadStart.
Keep the unit in good working order and condition. Replace damaged parts immediately.
Use only recommended parts. To use unapproved parts may be dangerous and will invalidate your warranty.
The RoadStart must only be opened and checked by qualified service personnel. DO NOT disassemble the unit for any reason.
Keep children and unauthorised persons away from the work area.
Keep work area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.
If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.
When not in use re-charge every 30 days.
DO NOT smoke or allow a spark, or flame in the vicinity of the battery or engine.
DO NOT drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.
DO NOT use RoadStart to recharge dry cell batteries that are commonly used with home appliances. These batteries may explode and
cause personal injury and damage to property.
DO NOT charge or boost a frozen battery.
DO NOT use attachments other than those recommended. To do so may risk damage to the unit and other equipment and possible personal
injury.
DO NOT pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.
DO NOT operate in vicinity of flammable liquids or gases.
DO NOT recharge the unit with plugs, cables or attachments that are damaged. Replace such items immediately.
DO NOT use this product to perform a task for which it is not designed.
DO NOT store the unit in damp or wet locations or where the temperature may exceed 50°C.
DO NOT submerge the unit in water.
DO NOT use whilst under the influence of drugs, alcohol or intoxicating medication.
DO NOT leave the unit in a totally discharged state for an extended period of time as this may result in permanent damage.
D O NOT cross-connect the power leads from the RoadStart to the battery. Ensure that positive is to positive and negative is to negative.
Ensure that the unit is fully charged before storage.
© Jack Sealey Limited
INSTRUCTIONS FOR:
ROADSTART® EMERGENCY POWER PACK
12V PEAK AMPS 1700 DEKRA APPROVED
MODEL NO:
Risk
Caution:
Of
Risk of
Explosion.
Electric
Shock.
Original Language Version
PBI1812S
Use In A
Keep
Well
Away From
Ventilated
Sparks &
Area.
Flame -
Battery
Could Emit
Explosive
Gases.
PBI1812S
Issue: 1 - 30/04/14
Advertisement
Table of Contents
Related Manuals for Sealey ROADSTART PBI18112S
Summary of Contents for Sealey ROADSTART PBI18112S
- Page 1 PBI1812S MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
-
Page 2: Specification
It is particularly important to use an RCD with portable products that plug into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You can obtain a Residual Current Device through your Sealey dealer. - Page 3 The RoadStart is a power source for all 12V DC accessories that are equipped with a 12V accessory plug. Use it for power cuts and fishing or camping trips. Make sure the device to be powered is OFF before inserting the 12V DC accessory plug into the 12V DC accessory outlet. Original Language Version © Jack Sealey Limited PBI1812S Issue: 1 - 30/04/14...
-
Page 4: Maintenance
If it happens again, replace the 12V device. The battery in the RoadStart won't The battery is defective (will not accept a charge). Have the battery checked. hold a charge. Original Language Version © Jack Sealey Limited PBI1812S Issue: 1 - 30/04/14... - Page 5 3. Disconnect the wires from the battery terminals, taking care to avoid accidental arcing off the terminals. 4. Lift the battery out of the casing. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme.