Cisco Catalyst 9404R Switch Hardware Installation Manual page 162
Hide thumbs
Also See for Catalyst 9404R Switch:
- Installation note (32 pages) ,
- Hardware installation manual (192 pages)
Table of Contents
Advertisement
Performing the Initial Configuration
<output truncated>
end
Step 7
Save configuration and then verify running-configuration
Example:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
[OK]
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
*Aug 17 21:16:56.780: %PKI-4-NOCONFIGAUTOSAVE: Configuration was modified.
memory" to save new IOS PKI configuration
Switch> enable
Password: exampleenable
Switch#
Switch# show running-config interface GigabitEthernet0/0
Building configuration...
Current configuration : 118 bytes
!
interface GigabitEthernet0/0
vrf forwarding Mgmt-vrf
ip address 192.168.247.10 255.255.0.0
negotiation auto
end
Step 8
Ping an interface using the Ethernet management interface through the VRF
Switch# ping vrf Mgmt-vrf 192.168.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.0.1, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 1/1/1 ms
Switch#
*Aug 17 21:18:45.152: %PNP-6-PNP_DISCOVERY_STOPPED: PnP Discovery stopped (Config Wizard)
You have now completed the initial configuration of the switch, so you can now configure other interfaces
and features over a network connection without having to directly connect to the console port of the supervisor
module.
To use the CLI to perform additional configuration or management tasks, enter commands at the Switch>
prompt through the console port by using a terminal program or through the network by using Telnet. For
configuration information, see the switch software configuration guide along with the switch command
reference.
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
156
Initial Configuration for the Switch
Issue "write
- Quick Links:
- Catalyst 9404R Switch
- Catalyst 9407R Switch
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
