Configuring Your Device Based On A Site Profile - Cisco Catalyst 9404R Switch Hardware Installation Manual
Hide thumbs
Also See for Catalyst 9404R Switch:
- Installation note (32 pages) ,
- Hardware installation manual (192 pages)
Table of Contents
Advertisement
Configuring Your Device Based on a Site Profile
Figure 65: Basic Settings - Device ID and Location Settings
Step 3
In the Device Management Settings section, assign an IP address to the management interface. Ensure
that the IP address you assign is part of the subnet mask you enter.
Step 4
Optionally, enter an IP address to specify the default gateway.
Step 5
To enable access to the device using telnet, check the Telnet check box.
Step 6
To enable secure remote access to the device using Secure Shell (SSH), check the SSH check box.
Step 7
Check the VTP transparent mode check box to disable the device from participating in VTP.
If you did not select Wired Network, in the earlier step, continue to the next screen to verify your configuration
on the Day 0 Config Summary screen, and click Finish..
Figure 66: Basic Settings - Device Management Settings
Configuring Your Device Based on a Site Profile
To ease your configuration tasks and save time, choose a site profile based on where your device may be
installed and managed in your network. Based on the site profile you choose, your device is automatically
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
142
Initial Configuration for the Switch
- Quick Links:
- Catalyst 9404R Switch
- Catalyst 9407R Switch
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
