Table of Contents
Advertisement
Before using for the first time
Con@ctivity via a direct WiFi
connection (Con@ctivity 3.0)
Prerequisite: WiFi-enabled Miele
cooker hood
If you do not have a home network, you
can establish a direct connection
between the hob and the cooker hood.
Switch the cooker hood off.
Press and hold the (B*) control.
Press the (1*) control at the same
time.
* Cooker hoods with sensor controls.
2 will light up constantly, and 3 will flash
on and off.
The cooker hood is ready for
connection during the next two
minutes.
Switch the hob on.
Touch the 0 sensor control on any of
the numerical keybanks.
Touch and hold the 0 and 7 sensor
controls on the numerical keybank at
the same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the
6 seconds have elapsed, a progress
light appears during the connection
attempt. If the connection was
successful, the code : appears in
the timer display. If the connection
could not be established, the timer
display will show the code :. Repeat
the steps above.
When successfully connected, 2 and 3
will light up constantly on the cooker
hood.
28
Quit connection mode on the cooker
hood by pressing the run-on
control .
Con@ctivity has now been activated.
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network. If this
is desired later, the direct WiFi
connection between the hob and the
cooker hood must first be
disconnected (see "Resetting
settings" and "Disconnecting the
WiFi" in the operating and installation
instructions for the cooker hood).
Hide quick links:
Advertisement
Table of Contents
