Configuration Examples For Port Security; Information About Protocol Storm Protection - Cisco Catalyst 2960-XR Security Configuration Manual
Ios release 15.0 2 ex1
Hide thumbs
Also See for Catalyst 2960-XR:
- Configuration manual (196 pages) ,
- Configuration manuals (120 pages) ,
- Reference (52 pages)
Table of Contents
Advertisement
Configuring Port-Based Traffic Control
Configuration Examples for Port Security
This example shows how to enable port security on a port and to set the maximum number of secure addresses
to 50. The violation mode is the default, no static secure MAC addresses are configured, and sticky learning
is enabled.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security maximum 50
Switch(config-if)# switchport port-security mac-address sticky
This example shows how to configure a static secure MAC address on VLAN 3 on a port:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# switchport mode trunk
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security mac-address 0000.02000.0004 vlan 3
This example shows how to enable sticky port security on a port, to manually configure MAC addresses for
data VLAN and voice VLAN, and to set the total maximum number of secure addresses to 20 (10 for data
VLAN and 10 for voice VLAN).
Switch(config)# interface tengigabitethernet1/0/1
Switch(config-if)# switchport access vlan 21
Switch(config-if)# switchport mode access
Switch(config-if)# switchport voice vlan 22
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security maximum 20
Switch(config-if)# switchport port-security violation restrict
Switch(config-if)# switchport port-security mac-address sticky
Switch(config-if)# switchport port-security mac-address sticky 0000.0000.0002
Switch(config-if)# switchport port-security mac-address 0000.0000.0003
Switch(config-if)# switchport port-security mac-address sticky 0000.0000.0001 vlan voice
Switch(config-if)# switchport port-security mac-address 0000.0000.0004 vlan voice
Switch(config-if)# switchport port-security maximum 10 vlan access
Switch(config-if)# switchport port-security maximum 10 vlan voice
Related Topics
Port Security, on page 336
Enabling and Configuring Port Security, on page 340
Information About Protocol Storm Protection
Protocol Storm Protection
When a switch is flooded with Address Resolution Protocol (ARP) or control packets, high CPU utilization
can cause the CPU to overload. These issues can occur:
• Routing protocol can flap because the protocol control packets are not received, and neighboring
OL-29434-01
adjacencies are dropped.
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
Configuration Examples for Port Security
347
Hide quick links:
Advertisement
Table of Contents
