Table of Contents
Advertisement
Cisco 910 Industrial Router Installation
Preparing for Installation
Warning:
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the
translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning:
Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious
burns or weld the metal object to the terminals. Statement 43
Warning:
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332
Warning:
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Warning:
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning:
Read the installation instructions before you connect the system to its power source. Statement 1004
Warning:
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 20A. Statement 1005
Warning:
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning:
The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device. Statement 1019
Warning:
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning:
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Warning:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning:
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning:
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection:
10/100/1000 Ethernet. Statement 1044
Warning:
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: Statement 1047
140°F (60°C) (with SSD)
140°F (60°C) (without SSD card and in a sealed enclosure)
158°F (70°C) (without SSD card and in a vented enclosure)
Warning:
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning:
To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
3 inches (7.6 cm). Statement 1076
21
Advertisement
Table of Contents
