Table of Contents
Advertisement
Cisco 910 Industrial Router Installation
Installing the Antenna
Installing the Router on a DIN Rail
For indoor use, DIN rail mount is the default mounting solution. The router ships with a DIN mount bracket on the rear
panel for the mounting on a standard 7.5-mm DIN rail.
Note:
The DIN mount bracket is already installed with four screws on the rear panel of the device when shipped.
To mount the router to a DIN rail, follow these steps:
1.
Position the DIN mount bracket directly in front of the DIN rail, making sure that the DIN rail fits in the space on the
DIN mount bracket. See
Figure 2
Mount to a DIN Rail
2.
Push the clip at the bottom of the DIN mount bracket to lock the DIN rail.
3.
After the router is mounted on the DIN rail, connect the power.
Installing the Router on a Wall or Pole
For outdoor use, install the chassis of the router into an IP55-certified dust-and-water protection enclosure. After this,
install the assembled IP55 case to a wall or a pole.
For detailed installation procedures of assembling the IP55 case and mounting the device to a wall or pole, see the
Mounting Kit Assembly Guide for the Cisco 910 Industrial Router.
Installing the Antenna
This section describes the installation of antenna for indoor and outdoor use.
Figure
2.
Push clip to lock
the DIN Rail
29
1
Advertisement
Table of Contents
