Table of Contents
Advertisement
LPBKTERMINAL (TRUNK)
DETAILED STEPS
Complete the
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
LPBKTERMINAL (TRUNK)
Default Severity: Not Alarmed (NA), Non-Service Affecting (NSA)
Logical Object: TRUNK
A Loopback Terminal condition on MXP or TXP trunk card indicates that there is an active terminal (inward)
loopback on the port.
For information about troubleshooting, refer to the
Paths With Loopbacks, on page 7
Clear the LPBKTERMINAL (TRUNK) Condition
SUMMARY STEPS
1. Complete the
455
DETAILED STEPS
Complete the
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
LSC-NOT-PRESENT-MIC-IN-USE
Default Severity: Major (MJ), Non-Service-Affecting (NSA)
Logical Object: EQPT
The LSC Not Present Mic In Use alarm is raised when the LSC is not present, and use LSC option is checked
in CTC.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
298
section.
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
procedure.
http://www.cisco.com/c/en/us/support/index.html
Troubleshooting MXP, TXP, XP, or ADM-10G Circuit
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting
procedure.
procedure.
Advertisement
Table of Contents
Troubleshooting
