Cisco MDS 9000 Series Configuration Manual page 250
Security
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Enabling Auto-learning
• If the port security feature is activated, auto-learning is enabled by default (unless you explicitly disabled
Tip
If auto-learning is enabled on a VSAN, you can only activate the database for that VSAN by using the force
option.
Enabling Auto-learning
To enable auto-learning, follow these steps:
Procedure
Step 1
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# port-security auto-learn vsan 1
Enables auto-learning so the switch can learn about any device that is allowed to access VSAN 1. These
devices are logged in the port security active database.
Disabling Auto-learning
To disable auto-learning, follow these steps:
Procedure
Step 1
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# no port-security auto-learn vsan 1
Disables auto-learning and stops the switch from learning about new devices accessing the switch. Enforces
the database contents based on the devices learned up to this point.
Auto-learning Device Authorization
The following table summarizes the authorized connection conditions for device requests.
Cisco MDS 9000 Series Security Configuration Guide, Release 8.x
232
this option).
Configuring Port Security
Advertisement
Chapters
Table of Contents
