Disabling Bandwidth Fairness; Taking Interfaces Out Of Service - Cisco MDS 9000 Series Configuration Manual
Interface
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Disabling Bandwidth Fairness
Step 2
switch(config)# rate-mode bandwidth-fairness module 1
Enables bandwidth fairness for a module.
Note
You must enter this command separately for each module for which you want to enable bandwidth fairness.
You must reload the module for the command to take effect.
Step 3
switch(config)# exit
Exits configuration mode.
Disabling Bandwidth Fairness
Note
If you disable bandwidth fairness, up to a 20 percent increase in internal bandwidth allocation is possible for
each port group; however, bandwidth fairness is not guaranteed when there is a mix of shared and full-rate
ports in the same port group.
To disable bandwidth fairness on a switching module, perform these steps:
Step 1
switch# configure terminal
Enters configuration mode.
Step 2
switch(config)# no rate-mode bandwidth-fairness module 1
Disables bandwidth fairness for a module.
Note
You must enter this command separately for each module for which you want to disable bandwidth fairness.
You must reload the module for the command to take effect.
Step 3
switch(config)# exit
Exits configuration mode.
Taking Interfaces out of Service
You can take interfaces out of service on Generation 2 and Generation 3 switching modules. When an interface
is out of service, all the shared resources for the interface are released as well as the configuration associated
with those resources.
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
100
Configuring Fibre Channel Interfaces
- Quick Links:
- E Port
- Configuring Isl between Two Switches
Hide quick links:
Advertisement
Table of Contents
