Pluggable Module; Latch Lock Screw; Sim Access Plate - Cisco IR1101 Hardware Installation Manual
Industrial integrated services router
Hide thumbs
Also See for IR1101:
- Hardware installation manual (86 pages) ,
- Manual (26 pages) ,
- User manual (26 pages)
Table of Contents
Advertisement
6.
If you are using this router in a vehicle, attach the ring terminal to the chassis using one of the screws provided and
the green or green and yellow striped wire. Connect the other end of the wire to the vehicle ground.
After you install and properly ground the router, you can connect the power wiring, the LAN cables, and the cables for
administrative access as required for your installation.
Pluggable Module
The Pluggable Module provides the IR1101 with a number of different configuration options. In this section the modular
cellular modem Pluggable Module remove and replace option is shown.
The IR1101 may have a blank plate covering the Pluggable Module slot. This will need to be removed prior to installing
the cellular modem module. The following example shows the LTE Pluggable Module.
1.
Remove the blank plate by unscrewing the latch lock screw(1) that holds the plate secure. See
Figure 8
Latch Lock Screw
2.
Slide the blank plate out of the device.
3.
Prepare the cellular modem module by inserting the micro sims applicable for your modems into the device. Remove
the screw (1) holding the access plate in place that covers the sim slots. It is located on the side of the module, as
shown in
Figure 9
Figure 9
Sim Access Plate
4.
Install your sims as shown in
Figure
10. Make note of the proper slot number and sim orientation.
34
Figure
8.
Hide quick links:
Advertisement
Table of Contents
