Table of Contents
Advertisement
Chapter 5
PIX 520
Remove the chassis cover as shown in
Step 4
Figure 5-12 Removing the Chassis Cover
1 in.
Replacing the Chassis Cover
Caution
Do not operate PIX security appliance units without the chassis cover installed. The chassis cover
protects the internal components, prevents electrical shorts, and provides proper air-flow for cooling the
electronic components.
To replace the chassis cover, perform the following steps:
Replace the chassis cover, as shown in
Step 1
Secure the three screws.
Step 2
Reinstall all interface cables.
Step 3
Figure 5-13 Replacing the Chassis Cover
78-15170-03
PIX Fir ew all
RESET
SERI ES
PIX Fir ew all
RESET
SERI ES
Removing and Replacing the PIX 520 Chassis Cover
Figure
5-12.
Pull lid 1 in. (50 mm)
back and then lift up
Figure
5-13.
Cisco PIX Security Appliance Hardware Installation Guide
5-11
Hide quick links:
Advertisement
Table of Contents
