Table of Contents
Advertisement
Installing Modules and Cables in the Chassis
Figure 91: Cable-Management Bracket Installation and Removal
1
Step 3
Insert and tighten the captive screw(s) to secure the bracket.
Step 4
Connect all the cables to the intended ports and pass them through the cable management bracket in an
organized manner.
Removing a Cable-Management Bracket
To remove a cable-management bracket, follow these steps:
Procedure
Step 1
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2
Note the current interface cable connections to the ports on the RP.
Step 3
Starting with the interface cable for the bottom port on the RP, disconnect the cable from the RP interface.
Step 4
Repeat Step 3 for all remaining interface cables, proceeding from the bottom ports upward, then proceed to
Step 5.
Step 5
Loosen the captive installation screw on the cable-management bracket and remove the bracket from the
chassis (see the above figure).
Cable-Management Bracket
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
Removing a Cable-Management Bracket
89
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
