Table of Contents
Advertisement
config cts debug enforcement host_ip
config cts debug enforcement host_ip
To filter the SGACL enforcement debugs based on the host IP, use the config cts debug enforcement host_ip
command.
config cts debug enforcement host_ip {ipv4 dst-ip [src-ip] | ipv6 dst-ip [src-ip]}
Syntax Description
ipv4 dst-ip [src-ip]
ipv6 dst-ip [src-ip]
Privileged EXEC (#)
Command Modes
Command History
Release
8.1.111.0
The following example shows you how to filter the IPv4 SGACL enforcement debugs based on the
host IP:
cisco-wave2-ap# config cts debug enforcement host_ip ipv4 209.165.200.224 209.165.200.227
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
38
Displays only the IPv4 SGACL enforcement debugs based on the destination and,
optionally, source IP addresses
Displays only the IPv6 SGACL enforcement debugs based on the destination and,
optionally, source IP addresses
Modification
This command was
introduced.
config Commands
- Quick Links:
- Capwap Ap
Hide quick links:
Advertisement
Table of Contents
