Configuring Ha / Pdsn Gy Interface Support - Cisco ASR 5000 Administration Manual
Ip services gateway
Hide thumbs
Also See for ASR 5000:
- Administration manual (466 pages) ,
- Installation manual (294 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
Gy Interface Support
context <context_name>
Notes:
For information on configuring IP access lists, refer to the Access Control Lists chapter in the System
Administration Guide.
For more information on configuring ECS ruledefs, refer to the ACS Ruledef Configuration Mode Commands
chapter in the Command Line Interface Reference.
For more information on configuring ECS charging actions, refer to the ACS Charging Action Configuration
Mode Commands chapter in the Command Line Interface Reference.
For more information on configuring ECS rulebases, refer to the ACS Rulebase Configuration Mode Commands
chapter in the Command Line Interface Reference.
Configuring HA / PDSN Gy Interface Support
To configure HA / PDSN Gy interface support, use the following configuration:
configure
context <context_name>
OL-27210-02
diameter dictionary <dictionary>
failure-handling initial-request continue
failure-handling update-request continue
failure-handling terminate-request continue
exit
exit
apn <apn_name>
selection-mode sent-by-ms
ims-auth-service <service>
ip access-group <access_list_name> in
ip access-group <access_list_name> out
ip context-name <context_name>
active-charging rulebase <rulebase_name>
credit-control-group <cc_group_name>
end
diameter endpoint <endpoint_name>
Cisco ASR 5000 IP Services Gateway Administration Guide ▄
Configuring Gy Interface Support ▀
135
Advertisement
Table of Contents
